£1,890.00£2,245.00 exc VAT

SKU: 70bb39b45804

Earn up to 2,245 Points.



Single-phase TIG Welder inverter power source for TIG and MMA-SMAW use, not including AWS6010 cellulosic electrodes, designed for maintenance work and small production batches.
This inverter welder works with pulsed arc, for use on thin material where heat transfer must be minimal and is set up for remote control using the foot control, remote control or up-down command on the torch. (all available as additional options above).
The following gases may be used for protection:

  • Argon
  • Argon/Helium
  • Hydrogen Argon

In TIG mode, the arc is started either in high frequency or by contact with the Cebora lift system. It is also possible to save up to 9 welding programs in memory.

The compliance with EN 61000-3-12
brings substantial energy saving and a wide supply voltage tolerance (+15% / -20%).
The power source can be powered by motor generators of adequate power (Min. 6 KVA).


= standard           = optional

Feature Power source part number
264 265 360
364 365 363
Max. pulse frequency 2.5 kHz
Max. pulse frequency 500 Hz
High Frequency ignition
“Lift by Cebora” ignition
Spot welding mode
2 times / 4 times
3 level mode
2 level and 4 time mode
Minimum current in AC TIG 5 A n.a. n.a. n.a. n.a.
Max. AC frequency 150 Hz n.a. n.a. n.a. n.a.
Crater current adjustment
Wave form selection n.a. n.a. n.a. n.a.
AC horizontal balance n.a. n.a. n.a. n.a.
AC vertical balance (AAd) n.a. n.a. n.a. n.a.
Remote control
Synergic parameters
Slope up adjustment
Slope down adjustment
Pre-gas adjustment
Post-gas adjustment
Load controlled fan
Job mode
Interface for cooling unit
Ready for automatic Plasma Welding console
Ready for manual Plasma Welding console
Interface for TIG Hot / Cold Wire feeder
Ready for interfacing with robot via either analog or fieldbus
TIG MIX process n.a. n.a. n.a. n.a.
EVO Start (ESt) adjustment
HF ignition by “EVO Lift” (ELF)
Panel locking
Digital gas control
Quality Control function
DC MMA welding
AC MMA welding n.a.
“Arc Force” function in MMA welding
“Hot Start” current
USB interface
RS-232 interface
Possibility to update the software
Conformity with EN61000-3-12 (PFC)
Suitable for use in environments with increased hazard of electric shock
IP23S protection class
The power source can be powered by motor generators of adequate power
Single phase power supply 230V +15% / -20%
Three-phase power supply 400V ±10%
Multivoltage single phase power supply 115 – 230V +15% / -20%
Multivoltage three-phase power supply 208-220-230-400-440V ±10%

Additional information


Foot Pedal (5mtr), Up Down Remote, None


Cebora Welding & Cutting


There are no reviews yet.

Be the first to review “TIG WELDER INVERTER BI-WELDER 2040 DC -HF 110/240V”

Your email address will not be published. Required fields are marked *